Zephyx

Suspension set OSIX 2; MKH50

Z-Cable-X, short XLR3 Male/Female cable for Zephyx with OSIX 1 or 2. Flexible near mic, reinforced near XLR, PCB integrated in central axis.

Z-FUR-LP-B/G, long pile fur for Zephyx. +4–5 dB attenuation from 20–200 Hz vs. short fur. Minor acoustic loss. Use only with Z-COVER.

Z-CAGE – Main cage with cross structure and isolators, designed for the ZEPHYX windshield system.

Suspension set for 2 CMC, stereo MS

[KIT-2AX-Z] “2AX” Swivel KIT for ZEPHYX with second swivel axis; directional control for stereo or fixed setups using stable, vibration-isolated design.

Cinela Z-AX – Central axis with dual swivel for ZEPHYX or ALBERT, with XLR holder and 3/8" mount.

Z-FUR-SP-B/G, short pile fur for Zephyx. Used with Z-COVER. Less attenuation than long pile, with minimal acoustic impact.

Z-BELLOWS – Flexible seal between Z-AX and Z-CAGE for optimal wind protection and vibration isolation.

Zephyx Back cap

Z-SW-BASE, swivel base with XLR holder for use with Zephyx, Piano, and Albert windshields. Enables precise microphone positioning.

Suspension set for MiniCMIT/CCM8

Suspension set OSIX 2; CMC

Z-Cable-XF, short XLR3 Male/Female cable for Zephyx with Sennheiser MKH 50. Flexible near mic, reinforced at XLR, PCB integrated in central axis.

Z-COVER, double-layer fabric cover for Zephyx. Black-grey polyester/polyamide. -1 dB @100 Hz, -2 dB @18 kHz. Helps with visual mic alignment.

Z-Cable-KM-MS, dual XLR3F to XLR5M cable for MS setup with two Neumann KMs in Zephyx. Flexible near mics, reinforced at XLR, PCB integrated in axis.

Suspension set for MS Neumann KM184/120

Suspension set for Schoeps CMXY

Suspension set for 4017C/CCM8

Zephyx inner cross

Suspension set for Double MS CCM8 + 2 CCM4(V)

Suspension set OSIX 1; KM100 and KM or KMA 184/185

Suspension set for CCM Mono

Z-Cable-CCM, short XLR3 Male/Female cable for Zephyx with Schoeps CCM. Flexible near mic, reinforced at XLR, PCB integrated in central axis.