Collection

XLR cable. XLR 3 pin female to XLR 3 pin male, 6mm, 10meter

M2T/E01 with Dante Digital Duet IEM/IFB half-rack with Dante 4×4, four inputs, two stereo channels, RF 10/25/50 mW, 470–614.375 MHz.

[131019] MK 5 Switchable capsule from the Colette series with selectable omni or cardioid patterns for flexible use in changing recording conditions.

[121104] Compact microphone, cardioid, side addressed, with permanently attached XLR cable, with SGC.

[044400] SX-RC8+ 8-fader remote controller for SX-R4+, SX62R and SX-R4+; 100 mm motorized faders, OLED displays, USB host/device and GPIO.

main frame + master module + PSU

[U-MM-6060-WHT] MiniMount white Low-profile mount for DPA 6060; hardened plastic with smooth surface, hand-finished for silent and discreet microphone placement.

Waist, Large, Black, 95-128cm, 100mm width, Big Pouch

Plastic Case – plastic case for COS-11D and COS-11DR. Extra or replacement unit of the standard supplied case.

VL-2X2C – 2-channel V-Lok charger with 4A charging current per channel, simultaneous charging of two batteries.

LEONARD windscreen 25mm WITH fur

PIANISSIMO windshield XLR5 (4017 C, CCM8, Fur)

WindKiller Extra Large Fur Windscreen. Lengte inwendig 180mm.

[U-FOAMIEPAD-CRML] Foamie Pad 15 Pack caramel; soft foam pads for lavaliers reduce clothing rustle, isolate contact noise and remain discreet under clothing.

[U-SOFTSOLES-MULTI] Soft Soles & Heavy Duties Multipack: 20 pre-cut shapes + 2 Soft Soles and 2 Heavy Duties sheets; high grip, residue-free removal on set.

[KSULH1] Stingray Harness LITE 1 harness for Stingray mixer bags with low carry position, ventilated back panel and adjustable straps for long shooting days.

[VRX-H] 1/4" thread mount holder for Zaxcom VRX receivers; vertical or horizontal positioning, 3 mounting points and rear access to the battery compartment.

[BCC-CCCC-X] Power cable with four battery cup inputs and one XLR4 output. With telemetry for redundant power supply and battery status.

[BCC-CCCT-H] Power cable with three battery cup inputs and one TA4M input to HRS4 output. With telemetry for redundant power supply and battery status.

[TRIAD-CCC-X] Power cable with three battery cup inputs and one XLR4 output. Passive combiner without telemetry for redundant power supply.

[TRIAD-CCT-T] Power cable with two battery cup inputs and one TA4M input to TA4M output. Passive combiner without telemetry for redundant power supply.

[DYAD-CT-X] Power cable with one battery cup and one TA4M input to XLR4 output. Passive combiner without telemetry for redundant power supply.

VSKEXMC3 moleskin Extreme Multicolor – Set of 12 hypoallergenic strips (2.2 × 8 cm), 4 white, 4 beige, and 4 black, with wire for silent lavalier placement.

[NP1PC] – Power adapter for NP1 batteries. Strong retention and available with Hirose 4p (straight/angled), XLR4 female or TA4 angled. Cable length 45 cm.